Adjusting Alignment (HN1000/HN3000)
If the alignment is incorrect, you can adjust the position on the timecard where the punches will print. Under the HN 2 menu, when the code “02” appears, set the position (up/down) where the punch will print. Use the + and - buttons to make your selection (0-9), then press Enter to confirm the setting.
When the code “03” appears, set the position (right/left) where the punch will print. Use the + and - buttons to make your selection (0-9), then press Enter to confirm the setting.
NOTE: It is recommended that you leave these settings at the default.